Of course not even though the rays are ultraviolet light purplish similar but do not have the nature of the burn, just removing the beam with a particular wavelength that necessary plant (later explained how the wavelength of light)
Perhaps by way of the earlier development of lighting plants less safe or slow, maybe with this light can grow fast crops though in space (indoor).
Benefits and perks
can save up to 80% of electrical energy as a form of a green solution
a small room temperature is not too hot and can be controlled
LED lights are used for growing crops led is more durable than a regular bulb lights use
The right light spectrum to help photosynthesis
The disadvantage
Only an expensive production cost at the beginning, because the technology is still relatively rare, so the raw material production was still classified as high, but not so the main problem I believe the short term would turnover and also fast-growing crops without genetic engineering.
Step 1: Equipment and material
Drill tool
Solder
Cable to taste
Pengaris iron
Penick to facilitate drilling
and a few electronics knowledge to install series/parallel
CPU fan ($ 5000-1500)
Thermal paste
Bolt fasteners
Square aluminum heatsink
Led 3W 670mA anti-air driver
LED HPL (high power LED)
3W x 4 Blue (455nm)
3W x 4 Blue (445nm)
3W x 16 Deep red (660nm)
3W Red x 12 (630nm)
Step 2: Drilling
aluminum plate for lamp help size holder small bolts with drill 3 mm size iron
8-14V DC transformer
Step 3: Glue the led's to the panel
After mounting the heatsink then, the satin-finished star was then time peneplain thermal heat sink so that the heat drove with either aluminum foil, then fasten with bolts.
Step 4: Glue on the led's
Note the elegant layout of (+) and (-) don't get the upside and hard
Step 5: Soldering
After the led is mounted correctly, the led settings according to the position of color to make a proper light is obtained, then it is time connecting with the cables.
Step 6: Installation of the driver
Well, for this stage of the installation of led drivers modules i.e. anti-water with lots of LEDs. This driver requires the consumption of lies risk between 120V or 220
Step 7: Mounting the fan cooler
The installation of a cooling fan to help warm up the components so that circulation is better, in this manner will prolong the age of the equipment. This is not fan shows that the LED was hot because the LED light is not hot like other incandescent lamps isn't just a hot device, its light is also hot.
Since this method work 24 hours in a confined space because that's cool component is indispensable.
Step 9: Finished
Enough here just the explanation of making short led grow lights.
0 comments